Zoeller Rail & Disconnect Systems

Rail & Disconnect Systems
* Economical, reduces time and cost of removing a pump
* Safety, keeps personnel out of pits and out of contact with contaminates
* Inspections made quickly and easily
* Pipe rails, pull rods and intermediate brackets not included
* One intermediate guide rail bracket is required for every 10 feet of rail (use 39-0022 with 39-0003 and 39-0004)
Disconnect only (1 , 1 and 2 discharge):
Disconnect fitting used for shallow systems where guide rails are not necessary (pull rod not included)
Complete systems (1 and 2 discharge):
Rail and disconnect system for effluent or sewage pumps for removal and reinstallation of pumps without getting in or removing fluid from the pit (2 standoffs included)
Square Guide Rail Systems (1 , 1 and 2 discharge) Field Assembled features:
* Economical, reduces time and cost of removing pump
* Keeps personnel out of pits and out of contact with contaminants
* Inspections made fast and easy
* Single rigid stainless steel square rail design
* Stainless steel rail, nuts, bolts, fasteners and lifting bail
* Cast iron angle arm bracket and pump guide bracket
* Galvanized piping (stainless steel optional)
* Red brass disconnect fittings with Teflon coated Buna O ring seal
* PVC ball valve
* Cast iron check valve
* Optional stainless pull rods and lifting cables available
* Also available in prepackaged fiberglass basins
EZ Out Rail Systems (1 , 1 - 3 NPT discharge pumps) features:
* Sewage, storm water and effluent pump systems
* For concrete, steel or fiberglass tanks
* Allows for removal of pumps from ground level
* No confined space entry to service pump
* No pull rods or hold down rods
* No diaphragms
* Cast iron base elbow and positive machine fit with O ring seal provides a reliable seal
* Designers liability can be reduced by providing reasonable care in the design of submersible pump installations. Pumps are removable from above pump for inspection and service
* Guide rails direct the pump to and from the base elbow. Systems are supplied complete with base elbow, sealing plate, pump discharge elbow and upper rail bracket
* All systems us schedule 40 pipe rails (not included)
* A lifting bail is required for the following models to balance the pump and rail plate evenly:
#10-2315 for 50, 90 and 150 series pumps
#10-2316 for 130, 140, 260 and 270 series pumps
#10-0789 for 160, 180, 280, 290, 810, 815 and 820 series pumps
Other models already include proper lifting device
Rail Systems (3 and 4) Field Assembled features:
* Guide rail system is for removal and installation of flanged horizontal discharge pumps without getting in or removing fluid from pit
Flygt Guide Rail System Adapters:
* Adapter plates for retrofitting 3 and 4 horizontal ANSI flange discharge pumps to existing Flygt rail systems
* Cast iron construction
* Flange conforms to ANSI B16.10 fully flat. MSS SP-6
* For use with all 400, 600 and 700 series pumps with 3 or 4 discharge
* Flange gasket and stainless steel bolts included

Key Features:

• Rail System
• Cast Iron
• Stainless Steel
• EZ Out Disconnect
• Compatible With Both Vertical & Horizontal Discharge
• Adapts To Flygt & Meyers Pumps